For GI-Series
GI-179A
Special Activator that can be used with GI-1000B, GI-1040, GI-1032, GI-1120B, GI-1110B, and GI-650 to lower the modulus and increase the elongation.

GI-1000A-H.T.
This Activator increases the high temperature resistance from approximately 350° F to approximately 450° F.  The Activator will exhibit some inhibition sensitivity.

GI-2020A
This Activator will dramatically increase the library life of molds from approximately two years to at least ten years.

GI-UFC
Ultra Fast Catalyst can be used in place of or in combination with the standard Activator to produce a mold in approximately 30 minutes.

GI-245
An extremely soft, low modulus, high elongation, translucent rubber used in the special effects industry.

For P-Series
Pt Accelerator
This robust platinum catalyst, when added in small amounts, dramatically increases the speed at which the P-Series rubbers cure at room temperature.

The information contained on our website is, to our best knowledge, true and accurate, but all recommendations or suggestions are made without guarantee.  Since the conditions of use are beyond our control, Silicones, Inc. disclaims any liability incurred in connection with the use of our products and information contained herein.